Regrettably due to unprecedented demand we have taken the difficult decision to suspend new orders for some products for a short period of time until we have caught up on our existing orders.
Enter your email below to get a notification when this is back in stock.
This LED Awning Lights Kit is very quick and easy to install, please follow our helpful step-by-step guide below:
This LED Light kit is suitable for all occasions thanks to the stunning colour changing lights, providing a calm atmosphere to relax in or create a lively party atmosphere to entertain in!
This LED light kit consists of, LED light reel, 10m transformer cable/plug and remote control. Please see the picture as a reference.
The best way to begin installation is to lay all of the parts on the ground first to make sure that nothing is tangled and to remove the LED lights from the reel.
It is important to place the cable under where the awning arm bends. Allow the cable to be slightly slack in order for the awning arm to bend when closed without pulling the LED lights out of place.
The LED light strips will have red stickers on the back, please peel these stickers off and stick to the awning arms. It is a good idea to peel the stickers from the lights as you attach them to the awning arms in order to avoid anything else sticking to the lights.
You can now stick the LED Light Strip to the awning arm whilst slowly peeling the red sticker from the sticky backing.
There will be approximately 5m cable wires connected onto the strip. These wires will go across the front bar in order to keep them hidden.
You can now stick the other LED Light Strip to the other awning arm.
The next step is to connect the controllers and transformer together. The transformer cable is 10m long and must be kept indoors or outside in a waterproof box. The LED light strip is waterproof but the controller and transformer are not, please keep this in mind when installing.
Now simply plug everything in and use the handy remote control to change the colours and sequence of the lights. Sit back, relax and enjoy! Please note: you may have to pull a clear sticker out of the bottom of the remote to activate the controller.
Please see below for more installation and final set up images of this light kit.
Please note: If you're installing these light kits for a full cassette model. Please make sure you adjust the arms to 15 - 20 degrees. This will allow clearance space. If you have the angle at 20 - 30 degrees, the LED lights will touch the bottom of the cassette and won't close properly.
View
